地下水穿透情形下玻璃固化体的蚀变研究

玻璃固化体在高放废物处置库中的长期处置行为，是处置库安全评价的关键环节之一。本研究模拟极端情形下，地下水穿透包装容器与固化体接触后，固化体中元素的浸出和蚀变行为。结果表明，地下水与固化体接触后，各元素的浸出浓度迅速增大，在200 d后逐渐下降并趋于稳定；温度对固化体中不同元素浸出速率的影响不同，B和Si的浸出速率随温度的增加而增大，U和Re的浸出速率随温度的降低而增大；固化体蚀变程度随温度的升高而加重，但其蚀变层的形成会阻滞元素在其中的扩散，客观上降低了固化体蚀变速率；富Si处置环境有利于抑制固化体中元素的浸出。     

Frequency dependence of plasma characteristics at different pressures in cylindrical inductively coupled plasma source

The effects of driving frequency on plasma parameters and electron heating efficiency are studied in cylindrical inductively coupled plasma (ICP) source. Measurements are made in an Ar discharge for driving frequency at 13.56/2 MHz, and pressures of 0.4–1.2 Pa. In 13.56 MHz discharge, higher electron density (n_e) and higher electron temperature (T_e) are observed in comparison with 2 MHz discharge at 0.6–1.2 Pa. However, slightly highern_e andT_e are observed in 2 MHz discharge at 0.4 Pa. This observation is explained by enhanced electron heating efficiency due to the resonance between the oscillation of 2 MHz electromagnetic field and electron-neutral collision process at 0.4 Pa. It is also found that the variation ofT_e distribution is different in 13.56 and 2 MHz discharge. For ICP at 13.56 MHz, T_e shows an edge-high profile at 0.4–1.2 Pa. For 2 MHz discharge,T_e remains an edge-high distribution at 0.4–0.8 Pa. However, the distribution pattern involves into a center-high profile at 0.9–1.2 Pa. The spatial profiles ofn_e remain a center-high shape in both 13.56 and 2 MHz discharges, which indicates the nonlocal kinetics at low pressures. Better uniformity could be achieved by using 2 MHz discharge. The effects of gas pressure on plasma parameters are also examined. An increase in gas pressure necessitates the rise ofn_e in both 13.56 and 2 MHz discharges. Meanwhile, T_e drops when gas pressure increases and shows a flatter distribution at higher pressure.     

Experimental study on flame spread along fuel cylinders in high pressures

Flame spread over solid fuels in high‐pressure situations, such as nuclear containment shells during a pressurized period, has potential to result in catastrophic disaster, thus requiring further knowledge. This paper experimentally reveals the flame spread behaviors over fuel cylinders in high pressures. Polyethylene and polymethyl‐methacrylate cylinders with the diameter of 4.0 mm are used in this study. Ambient gas is air, and total pressures are varied from naturally normal pressure (100 kPa) to elevated pressure (500 kPa). Flame characteristics including flame appearance and flame size and burning rate and flame spread rate are investigated. Results show that in high pressure, the flame appearance is significantly affected. As the pressure increases, the blue flame disappeared, and the color of flame tip changes from luminous yellow to orange as well the orange part extends down towards the base of flame. The dimensionless flame height increases with pressure for pressure below 150 kPa and then decreases with pressure above that level. The burning rates show increasing trend with pressure and are proportional to P^0.6 and P^0.79 for polymethyl‐methacrylate and polyethylene, respectively. Besides, flame spread rates for polymethyl‐methacrylate and polyethylene both were found to be proportional to P^0.5.     

Heating frequency optimization for artificial field-aligned scattering

In this study, we present a simulation study of artificial field-aligned irregularities (AFAI) to calculate the scattering coefficient considering a Gaussian autocorrelation function for the wave number spectrum of the density fluctuation. By analyzing variations in the scattering coefficient under different ionospheric backgrounds, the optimal range of the heating frequency was found, which is about 0.9–1 times the critical frequency of the F2 layer. This is especially noticeable as when the heating frequency varies from 0.5 times to 0.9 times of the critical frequency, the scattering coefficient increases by 6.8–16.2 dB. These results should be useful for optimizing the heating frequency in the future artificial field-aligned scattering (AFAS) transmission applications at middle and low latitudes.     

Design of switchable band‐notched frequency selective absorber

An active band‐notched frequency selective absorber (BNFSA) with switchable notch band is proposed in this article. The BNFSA is a two‐layer structure composed of a lossy layer at the top and a ground plane at the bottom, separated by an air spacer. The element of the lossy layer is a lumped‐resistor‐loaded metallic dipole with a parallel LC resonance structure, which is realized by complementary n‐shaped resonator (CnR) inserted in the center, and PIN diode is welded at two arms of CnR. The bias circuit printed on the back of the substrate of the lossy layer connects to anode and cathode of the diode by via hole and isolates by the inductor. Simulation results show that the notch bands are located at 4.50 and 6.81 GHz when the diode sets to ON and OFF, respectively. To validate the performance of switchable BNFSA, the prototypes are fabricated and measured, reasonable agreement between simulated and measured results is obtained.     

Electromagnetic torque detecting for optimization of in-mould electromagnetic stirring in the billet and bloom continuous casting

ABSTRACT

In this paper, an electromagnetic torque device based on the theoretical model was established to determine the optimum frequency accurately and conveniently in billet and bloom continuous casting with in-mould electromagnetic stirring (M-EMS). Magnetic characteristics with M-EMS was investigated by numerical simulation and physical experiment with the application of electromagnetic torque device and gauss meter. In addition, the effects of stirring frequency with M-EMS on macro segregation and equiaxed crystal ratio were compared and analysed for 55SiCr with 150?mm?×?150?mm billet caster and BU with 310?×?360?mm bloom caster by a series of plant trials, respectively. The results showed that maximum magnetic flux density and maximum electromagnetic torque occurred with different frequency and same current in M-EMS, and central equiaxed crystal ratio and macro segregation has been significantly improved by optimum frequency with M-EMS.     

Microstructure,tribological behavior and magnetic properties of Fe−Ni−TiO2 composite coatings synthesized via pulse frequency variation

The Fe−Ni−TiO₂ nanocomposite coatings were electrodeposited by pulse frequency variation. The results showed that the nanocomposite with a very dense coating surface and a nanocrystalline structure was produced at higher frequencies. By increasing the pulse frequency from 10 to 500 Hz, the iron and TiO₂ nanoparticles contentswere increased in expense of nickel content. XRD patterns showed that by increasing the frequency to 500 Hz, an enhancement ofBCC phase was observed and the grain size of deposits was reduced to 35 nm. The microhardness and the surface roughness were increased to 647 HV and 125 nm at 500 Hz due to the grain size reduction and higher incorporation of TiO₂ nanoparticles into the Fe−Ni matrix (5.13 wt.%). Moreover, the friction coefficient and wear rate values were decreased by increasing the pulse frequency;while the saturation magnetization and coercivity values of the composite deposits were increased.     

关于构建塑料包装废弃物的分类、收集与管理体系的思考

简介了我国塑料包装行业发展状况和塑料包装废弃物治理的有关政策与法规；阐述了为解决塑料包装废弃物等对环境造成的污染不同主体应承担与落实的责任，包括政府部门、企业和消费者等；提出了为高值（质）化回收利用塑料包装废弃物构建细化分类、收集与管理体系的一些设想。     

Zika Virus Growth in Human Kidney Cells Is Restricted by an Elevated Glucose Level

Mosquito-borne Zika virus (ZIKV) became a real threat to human health due to the lack of vaccine and effective antiviral treatment. The virus has recently been responsible for a global outbreak leading to millions of infected cases. ZIKV complications were highlighted in adults with Guillain–Barré syndrome and in newborns with increasing numbers of congenital disorders ranging from mild developmental delays to fatal conditions. The ability of ZIKV to establish a long-term infection in diverse organs including the kidneys has been recently documented but the consequences of such a viral infection are still debated. Our study aimed to determine whether the efficiency of ZIKV growth in kidney cells relates to glucose concentration. Human kidney HK-2 cells were infected with different ZIKV strains in presence of normal and high glucose concentrations. Virological assays showed a decrease in viral replication without modifying entry steps (viral binding, internalization, fusion) under high glucose conditions. This decrease replication was associated with a lower virus progeny and increased cell viability when compared to ZIKV-infected HK-2 cells in normal glucose concentration. In conclusion, we showed for the first time that an elevated glucose level influences ZIKV replication level with an effect on kidney cell survival.     

Enhanced electrical and photoluminescence properties of BiSbO4-doped CaCu3Ti4O12 ceramics by modifying grain boundary response

CaCu₃Ti₄O₁₂-xwt%BiSbO₄ ceramics (CCTO-xwt%BSO, x = 0, 1, 2, 3) were prepared by solid-state reaction method. The microstructure, dielectric properties, varistor properties, photoluminescence properties of CCTO-xwt%BSO ceramics were studied in this work. Results showed that all samples formed CaCu₃Ti₄O₁₂ (CCTO) single phase. Doping BiSbO₄ (BSO) restrained the abnormal grain growth and increased the grain boundary density of ceramics. The introduction of BSO led to the increase of the grain boundary resistance, reducing the dielectric loss and enhancing the temperature stability of dielectric properties. The nonlinear electrical characteristics are enhanced with proper concentration of BSO. And the improved varistor performance with breakdown electric field of ～3.98–34.6 and nonlinear coefficient of ～1.49–2.96 are obtained for CCTO-xwt%BSO samples. In addition, the photoluminescent emission of the samples is enhanced with the addition of appropriate equivalent BSO, showing the potential applications in novel devices with photoluminescent/electrical multifunctional properties.